Fulton Where protection is required ordinance (§ 114-241)

(a) An approved backflow prevention assembly shall be installed on each service line to a consumer's water system serving premises where, in the judgment of the water purveyor or the state department of natural resources, actual or potential hazards to the public potable water system exist. The type and degree of protection required shall be commensurate with the degree of hazard.

(b) An approved air gap separation or reduced pressure principle backflow prevention assembly shall be installed at the service connection or within any premises where, in the judgment of the water purveyor or the state department of natural resources, the nature and extent of activities on the premises, or the materials used in connection with the activities, or material stored on the premises,

would present an immediate and dangerous hazard to health should a cross connection occur, even though such cross connection may not exist at the time the backflow prevention assembly is required to be installed. This includes but is not limit to the following situations:

(1) A premise which has an auxiliary water supply, unless the quality of the auxiliary supply is acceptable to the water purveyor and the state department of natural resources.

(2) Premises having internal cross connections that are not correctable, or intricate plumbing arrangements which make it impractical to ascertain whether or not cross connections exist.

(3) Premises where entry is restricted so that inspection for cross connections cannot be made with sufficient frequency or at sufficiently short notice to assure the cross connections do not exist.

(4) Premises having a repeated history of cross connections being established or reestablished.

(5) Premises, which due to the nature of the enterprise therein, are subject to recurring modification or expansion.

(6) Premises on which any substance is handled under pressure so as to permit entry into the public water supply, or where a cross connection could reasonably be expected to occur. This shall include the handling of process waters and cooling waters.

(7) Premises where materials of a toxic or hazardous nature are handled such that if back-siphoning or backpressure should occur, a serious health hazard may result.

(c) The types of facilities listed in section [114-246] fall into one or more of the categories of premises where an approved air gap separation or reduced pressure principle backflow prevention assembly is required by the water purveyor and the state department of natural resources to protect the public water supply and must be installed at these facilities unless all hazardous or potentially hazardous conditions have been eliminated or corrected by other methods to the satisfaction of the water purveyor and the state department of natural resources.

(d) The type of facility listed in section [114-247] are premises where an approved double check valve assembly is required by the water purveyor and the state department of natural resources as the minimum level of protection for the public water supply and must be installed at these facilities unless all hazardous or potentially hazardous conditions have been eliminated or corrected by other methods to the satisfaction of the water purveyor and the state department of natural resources.

(e) Customer facilities not listed in section [114-246] or section [114-247] may be designated a backflow hazard by written notification from the water purveyor. The notice shall specify the nature of the customer activity that necessitates designation of the facility as a backflow hazard, the type of backflow protection required and the date by which the customer shall install or construct the required assembly.